Edwards Lifesciences

Vigilance Monitor Venous O2 Abbreviated Instructions for Use

Abbreviated Instructions for Use

2 Pages

04 ED AR00462 Vigilance Card  2/11/04  9:59 AM  Page 1  Edwards Vigilance Monitor Venous Oxygen Saturation Abbreviated Instructions for Use To Perform In Vitro Calibration: 1. Connect catheter to optical module. Connect optical module to Vigilance Monitor. 2. Press SvO2 on blue touch bar. 3. Select IN VITRO CALIBRATION on the touch bar. 4. Use the CURSOR key to select HGB (hemoglobin) OR Hct (hematocrit). a. Use default value or enter lab value using touch bar. 5. Press the CAL key. 6. Upon completion of a successful calibration, the monitor will display the following message: “In Vitro Calibration OK. Insert Catheter then press Start SvO2”. 7. Remove catheter from tray. 8. Flush catheter. a. Never flush lumens before In Vitro Calibration. b. If using a Swan-Ganz catheter, check balloon. 9. Insert catheter into appropriate position as indicated on the product’s “Directions for Use” sheet. 10. Press START SvO2.  To Perform In Vivo Calibration: 1. Press SvO2 on blue touch bar. 2. Confirm catheter position and SQI before performing – Press IN VIVO CALIBRATION. 3. Press DRAW, after checking for SQI of 1 or 2. 4. Slowly draw waste sample and discard. Slowly draw lab sample and send for analysis by co-oximeter. 5. Use the CURSOR to select value, enter lab results using touch bar. 6. Press CAL.  To Transport: 1. After reconnecting patient cable and optics module to the Vigilance Monitor, WAIT 20 SECONDS, press SvO2 on touch bar. 2. Press TRANSPORT. 3. Press RECALL. a. Calibration data must be less than 24 hours old. b. Make sure time and date match if using different monitors.
File Type: PDF
File Size: 367 KB
File Name: vigilance_monitor_venous_o2_abbreviated_instruction.pdf

By clicking Download you are confirming this is the correct document for your purposes
and that you agree to our Terms & Conditions